DR ANTHONY MELVIN CRASTO,WorldDrugTracker, helping millions, A 90 % paralysed man in action for you, I am suffering from transverse mylitis and bound to a wheel chair, With death on the horizon, nothing will not stop me except God
DR ANTHONY MELVIN CRASTO Ph.D ( ICT, Mumbai) , INDIA 30 Yrs Exp. in the feld of Organic Chemistry. Serving chemists around the world. Helping them with websites on Chemistry.Millions of hits on google, world acclamation from industry, academia, drug authorities for websites, blogs and educational contribution
n

Sunday 25 September 2016

A high-yielding method for the preparation of isoxazolopyridin-3-amine derivatives

Image result for A high-yielding method for the preparation of isoxazolopyridin-3-amine derivatives








A highly efficient and green method has been developed for the rapid preparation of highly functionalized isoxazolopyridin-3-amine derivatives in excellent yields. This process has a broad substrate scope, is operationally simple, and generally requires no chromatographic purification. In addition, the process is scalable and significantly greener than current alternatives with a PMI of 18 and water as the reaction solvent.



Graphical abstract: A high-yielding method for the preparation of isoxazolopyridin-3-amine derivatives


Image result for A high-yielding method for the preparation of isoxazolopyridin-3-amine derivatives

Image result for A high-yielding method for the preparation of isoxazolopyridin-3-amine derivatives









































Image result for A high-yielding method for the preparation of isoxazolopyridin-3-amine derivatives











Image result for A high-yielding method for the preparation of isoxazolopyridin-3-amine derivatives


Image result for A high-yielding method for the preparation of isoxazolopyridin-3-amine derivatives



A rapid preparation of highly functionalized isoxazolopyridin-3-amine and other heterocyclic fused aminoisoxazole derivatives


A high-yielding method for the preparation of isoxazolopyridin-3-amine derivatives

Wensheng Yu,*a   Paul G. Bulgerb and   Kevin M. Maloney*b  

*
Corresponding authors
a
Discovery Chemistry, Merck Research Laboratories, 126 E. Lincoln Avenue, Rahway, USA
E-mail: wensheng.yu@merck.com
b
Process Chemistry, Merck Research Laboratories, 126 E. Lincoln Avenue, Rahway, USA
Green Chem., 2016,18, 4941-4946

DOI: 10.1039/C6GC01125J















http://pubs.rsc.org/en/Content/ArticleLanding/2016/GC/C6GC01125J?utm_source=feedburner&utm_medium=feed&utm_campaign=Feed%3A+rss%2FGC+%28RSC+-+Green+Chem.+latest+articles%29#!divAbstract


Wensheng Yu


Wensheng Yu

Associate Principal Scientist at Merck



Image result for Paul G. Bulger merck

Paul G. Bulger was born in London, England, in 1978. He received his undergraduate M.Chem degree in 2000 from the University of Oxford, completing his Part II project under the supervision of Dr. Mark G. Moloney. He remained at Oxford for his graduate studies, obtaining his D. Phil. in chemistry in 2003 for research conducted under the supervision of Professor Sir Jack E. Baldwin. After an enjoyable three-year stint as a postdoctoral researcher in Professor K. C. Nicolaou's group at The Scripps Research Institute, he joined the Process Research Department of Merck & Co., Inc. in the fall of 2006.






pic not available



Kevin Maloney

Sr Research Chemist at Merck Sharp & Dohme


Experience


Sr Research Chemist

Merck
 – Present (9 years)

/////////////

Friday 23 September 2016

A Simple and Versatile Reactor for Photochemistry

Abstract Image
A photoreactor that generates a thin film upon rotation for efficient irradiation of solutions is described. The reactor is based around a standard piece of equipment found in most synthetic laboratories, namely, a rotary evaporator. Three different photo-oxidation reactions have been used to examine the effects of several parameters such as irradiated volume, flask size, rotation speed, and light intensity. The reactor can be operated in a semicontinuous manner, and two possible configurations are described. The thickness of the generated film and the rate of mixing under different conditions have been examined using in situ electronic absorption spectroscopy.

Safety warning: Any experiment involving flammable organic solvents and air or pure oxygen is potentially hazardous, especially when partially contained, as is the case of the flask of our reactor. We took the following precautions and encountered no problems but we stress the need for readers to make safety assessments for their own experiments as peripheral circumstances may be different from ours. All experiments were carried out in a fume hood or ventilated enclosure with adequate ventilation and the front lowered. Any obvious sources of ignition were removed. Oxygen was fed from a cylinder fitted with a compliant regulator and was delivered at a maintained pressure of 1 bar using a mass flow controller compatible with oxygen. The equipment was maintained and cleaned free of grease at all times to prevent any incompatibilities with oxygen. Temperatures were kept at ambient. When working above the solvent flash point and LOC, care must be taken to ensure that all possible risks have been considered. Appropriate safeguards and suitable safety measures must be implemented.




A Simple and Versatile Reactor for Photochemistry

School of Chemistry, Department of Mechanical, Materials and Manufacturing Engineering, The University of Nottingham, University Park, Nottingham NG7 2RD, United Kingdom
§ Department of Chemical and Environmental Engineering, The University of Nottingham Ningbo China, 199 Taikang East Road, Ningbo 315100, China
Org. Process Res. Dev., Article ASAP
DOI: 10.1021/acs.oprd.6b00257
*E-mail: martyn.poliakoff@nottingham.ac.uk (M.P.)., *E-mail: mike.george@nottingham.ac.uk (M.W.G.).

//////////

Monday 19 September 2016

Solid-Phase Peptide Synthesis of Dipeptide (Histidine-β-Alanine) as a Chelating Agent by Using Trityl Chloride Resin, for Removal of Al3+, Cu2+, Hg2+ and Pb2+: Experimental and Theoretical Study




Characterization of synthesised dipeptide (histidine-β- alanine) Dipeptide was successfully synthesized via the standard BOC method. The synthesis of dipeptide (histidine-β- alanine) was approved by using UV-Vis, FTIR, 1 H NMR and LC-MS analysis. The UV-Vis absorbance spectra of histidine-β-alanine obtained in water at 25 °C is presented in Figure 1. The results show that the maximum peaks were appeared at 214 and 264 nm, which can be assigned to Ï€→Ï€* and n→Ï€*, respectively.
FTIR (KBr) n / cm−1 3226 (NH2), 1641 (amide), 1563 (imidazol);

1H NMR (300 MHz, D2O) d 2.60 (m, 2 Hs, 12H), 2.92 (dd, 1 Hs, 6H), 3.08 (dd, 1 Hs, 6H), 3.16 (m, 2 Hs, 11H), 4.40 (dd, 1 Hs, 7H), 6.89 (s, 1 Hs, 4H), 7.66 (dd, 1 Hs, 2H), 7.89 (imidazole ring).

The LC-MS analysis showed a single mass peak in [M + H]+ and [M]− , which
correspond to molecular weight for dipeptide calculated for C9H14N4O3: 226.23; found m/z [M + H]+ : 227.000 and m/z [M]− : 224.800 (Figure 2).












J. Braz. Chem. Soc. 2016, 27(10), 1814-1819

Solid-Phase Peptide Synthesis of Dipeptide (Histidine-β-Alanine) as a Chelating Agent by Using Trityl Chloride Resin, for Removal of Al3+, Cu2+, Hg2+ and Pb2+: Experimental and Theoretical Study


Rahmatollah Rahimi; Maryam Khosravi; Mohammd H. H. Tehrani; Mahboubeh Rabbani; Ebrahim Safavi





Rahimi R, Khosravi M, Tehrani MHH, Rabbani M, Safavi E. Solid-Phase Peptide Synthesis of Dipeptide (Histidine-β-Alanine) as a Chelating Agent by Using Trityl Chloride Resin, for Removal of Al3+, Cu2+, Hg2+ and Pb2+: Experimental and Theoretical Study. J. Braz. Chem. Soc. 2016;27(10):1814-1819



Solid-phase peptide synthesis of dipeptide (histidine-β-alanine) as a chelating agent examined. Trityl chloride resin was used as a carrier.

http://dx.doi.org/10.5935/0103-5053.20160064

Published online: March 1, 2016

*e-mail: rahimi_rah@iust.ac.ir


Department of Chemistry

 Dr. Rahmatollah Rahimi
  Professor, Inorganic Chemistry Division
  E-mail address: Rahimi_Rah@iust.ac.ir
  Office Tele: 77240290, 77240-50(2718)
  Fax: 77491204

  AWT IMAGE

  Academic Degrees:
  Bachelor of Science: Chemistry, Howard University, USA, 1983
  Master of Science: Physical chemistry, Howard University, USA, 1987
  Ph. D.: Inorganic Chemistry, Howard University, USA, 1991

 Active Research fields:
  - Synthesis and characterization of porphyrins and metalloporphyrins and Investigation of their applications.
  - Photocatalysis process
  - Preparation and characterization of solar cells
  - Invironmental projects
  - Bioinorganic chemistry
  Teaching Experiences:
  A) Teaching Courses at undergraduate level:
  -General chemistry
  -Inorganic Chemistry
  -Physical chemistry
  -Physical chemistry laboratory
  -General Chemistry laboratory
  -Chemistry science literature

  B) Teaching Courses at graduate level (MS):
  -The professional language for Chemistry
  -Inorganic kinetics and Thermodynamics
  -Physical Inorganic Chemistry
  -Research method
  -Advanced Inorganic Chemistry
  -Bio Inorganic Chemistry

  C) Teaching Courses at graduate level (PhD):
  -Advanced Bio Inorganic Chemistry
  -Structures and bonds of inorganic components
  - Organometallic Chemistry
  Research activities:
  A) Scientific Research articles :
  More than 175 Articles Published at Conferences and Journals

  Patent:

1. “Application of LED lamps for treatment and disinfection of wastewaters using nanophotocatalysts” Rahmatollah Rahimi, Javad Shokraian, Mahboobeh Rabbani, 1393
2. “Synthesis of ZnO Nanorods in low temperature via Coprecipitation Method” Rahmatollah Rahimi, Marzieh Yaghoubi Berijani, Solmaz Zargari, 1393

3. “Synthesis of BiVO4 photocatalyst with two monoclinic and tetragonal phases, active in visible and ultraviolet region”, Rahmatollah Rahimi, Marzieh Yaghoubi Berijani, Solmaz Zargari, 1393
   
4. “Synthesis of polypyrrole-iron oxide functionalized with porphyrin as an efficient sorbent of industrial pollutions”, Rahmatollah Rahimi, Meisam Asadi Davati, Solmaz Zargari, 1392

5. “ Synthesis of Titanium dioxide (TiO2)-Vanadium phosphorous nanocomposite oxidized with silver (Ag-VPO) as a catalyst (Ag-VPO/TiO2) and is organic pollution degradation under visible light illumination”, Rahmatollah Rahimi, Masoumeh Mahjoub Moghaddas, Solmaz Zargari, 1391

6. “ Synthesis of SbVO4-TiO2 nanocomposite as a catalysts and its investigation in degradation of organic pollutions under visible light irradiation”, Rahmatollah Rahimi, Masoumeh Mahjoub Moghaddas, Solmaz Zargari, 1391
7. “Synthesis of Titanium dioxide-Bismut vanadat (BiVO4-TiO2) sensitized with porphyrin (TCPP) and its photocatalytic application under visible light irradiation”, Rahmatollah Rahimi, Masoumeh Mahjoub Moghaddas, Solmaz Zargari, 1391

8. “Preparation ofV-TiO2-TCPP and its concurrent application in removal anddegradation of industrial pollutants”, Rahmatollah Rahimi, Masoumeh MahjoubMoghaddas, Solmaz Zargari, 1391
9. “Preparation of Vdoped TiO2 mesoporous and sensitized with porphyrin over SBA-15substrate”, Ahmad Najafian, Masoumeh Mahjoub Moghaddas, Rahmatollah Rahimi, 1391

10. “Preparation ofporphyrin on SBA-15 catalysts”, Mehdi Deilam Kamar, Ahmad najafian, RahmatollahRahimi, 1391.

11. “Nanoporous TiO2solar cell sensitized with tetra(4-carboxyphenyl)porphyrin”, RahmatollahRahimi, Pegah Tvakoli fard, 2010


Image result for Rahmatollah Rahimi




///////////